|
Truck bed surface temperature should be at least 68°F for proper
installation.
Warning: Improper installation will result in liner flying out of truck!
Follow instructions exactly!!
|
|
- Read all instructions before installing.
- The floor and siderugs are shipped unzipped.
- Remove floor and siderugs from box.
- Zip floor and siderugs together to form the one-piece soft bed liner.
- A very aggressive hook and loop fastening system has been designed to hold the bedliner in open bed trucks.
- A continuous loop fastener is sewn around the liner. The bulkhead
and tailgate have two continuous strips of loop fastener sewn along
the top and bottom. The hook fasteners have a self-adhesive backing
to stick to the bed of the truck.
|
|
|
- Lay the Bedrug soft bed liner in the bed of the truck to determine
the exact location and fit.
Note: Some truck beds are equipped with tie-down hooks, load extenders
and other functional equipment. These may be located on the floor,
bulkhead or sidewalls. For equipment such as this, the installer must
either:
|
| |
|
- Cut a small slit in the appropriate area of the Bedrug allowing
the equipment to protrude through the Bedrug into the truck bed. (This
will not damage the Bedrug.) or
- Remove the equipment until the installation is complete, then reinstall
the equipment on top of the Bedrug.IMPORTANT: Never cut or put slits
through any seams or sewn areas of the Bedrug. This will cause the
seam to come completely apart.Refer to illustration for completing
steps 8 -14. Roll one side of the Bedrug up exposing the floor area
where the 3" strip of hook fastener is to be adhered.
|
|
- Roll one side of the Bedrug up, exposing the floor area, where
the 3" strip of hook fastener is to be adherred.
- Using a clean lint-free cloth, clean this area thoroughly using
NON-PETROLEUM based solvent. Then with a separate cloth, clean the
same area again with alcohol. If the cloths become visually soiled,
replace them with clean ones.
- Attach hook fasteners to the loop. For siderugs, be sure to place
the 2" long hook fasteners at the locator marks which are molded into
the foam. Remove the protective liners for the hook fasteners exposing
the adhesive. (See Illustration) Lay the Bedrug down, then FIRMLY
rub the fastener(s) down VERY AGGRESSIVELY to assure full engagement
of the fastener(s) and the adhesive.
Note: Truck bed surface temperature
should be 68°F or higher in order for the hook fastener to achieve
maximum adhesion. Also, never contaminate the adhesive by touching
it with your fingers.
- Repeat steps 9 and 10 for the opposite side of the Bedrug.
- Repeat steps 9 and 10 on the bulkhead.
- Repeat steps 9 and 10 on the siderugs.
- Repeat Steps 9 and 10 on the tailgate.
|
|
|
